Specifications

MP 700 Series GPS AT Command Reference
54 2130309
!MPPADCONN[n] Establish PAD connection
Initiates the PAD connection defined by the !MPPADSETUP command using
the configuration specified by the !MPPADCONF command.
Note: The MP 700 Series GPS source port number is hard coded and is 7238.
This port number should be used as the destination UDP port number by a
remote host sending PAD data to the modem.
The GPRS profile used in the connection is specified by n:
• <n>=1 Profile 1
• <n>=2 Profile 2
• <n>=3 Profile 3
Profiles are defined using the !MPSETUP command.
If n is not specified, the default profile is used. The default is defined by the
!MPSETDFLT command.
!MPPADSETUP=<ctype
>,
<ipaddr>,
<port#>,
<autoconn>
!MPPADSETUP?
Set up a PAD connection
Creates a UDP or TCP connection with a specified device. This defines the
connection established by the !MPPADCONN command.
Note: The MP 700 Series GPS source port number is hard coded and is 7238.
This port number should be used as the destination UDP port number by a
remote host sending PAD data to the modem.
Parameter settings
The supported values are:
• Connection type <ctype>=
0 Undefined
1 UDP
2 TCP
No data communication is possible when <ctype>=0.
• Destination IP address <IP address>=
IP address (in the form, nnn.nnn.nnn.nnn) of the destination device.
• Destination port number <port#>=
1 - 65535
• Autoconnection option <autoconn>=
0 Disabled (default)
1 Enabled
When enabled, the modem initiates a connection to the specified destination address
and port on power-up.
!MPPADSETUP? returns the PAD connection setup.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description