Specifications

Command Reference
Rev 3.2 Oct.05 103
V[<n>] (continued) Verbose result code format (continued)
This command also affects framing of responses (see page 20 for details).
Settings for <n> are:
• 0: Numeric result codes
• 1: Verbose result codes (default)
Result codes
• If <n>=0, the result code is 0.
• If <n>=1, the result code is OK. (The default.)
• ERROR or 4 results otherwise, depending on the current state (verbose or
not)
Z
Note: Additional
commands on the same
line are ignored.
Reset modem to user-defined profile
The modem disconnects any active call, and then resets the command and
register parameters to the defaults stored in the non-volatile memory’s user
profile by the AT&W command (see page 24).
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description