Operating instructions

Index
Drive converter cabinet units
Operating Instructions, 10/2008, A5E00288214A
527
Frame size HX, replacement, 442
Frame size JX, replacement, 446
Power connections, 54
Connecting the motor and power cables, 55
Power supply, internal, 59
Preparation
Mechanical installation, 36
PROFIBUS, 210
Bus terminating resistor, 211
Connectors, 211
Setting the PROFIBUS Address, 214
PROFIBUS link, 210
PROFINET IO, 250
Addresses, 252
RT and IRT, 251
Protecting power components, 405
Protective functions, 405
PT100 evaluation unit (option L86), 89
Q
Quality, 22
R
Ramp-function generator, 262
Reactive power compensation, 307
Reference mark search, 370
Reference model, 282
Relay outputs, 69
Removing the noise suppression capacitor, 60
Replacement
Crane lifting lugs, 435
Fan in the Active Interface Module (frame size
FI), 466
Fan in the Active Interface Module (frame size
GI), 468
Fan in the Active Interface Module (frame size
HI), 470
Fan in the Active Interface Module (frame size
JI), 472
Fan, frame size FX, 456
Fan, frame size GX, 458
Filter mats, 437
Installation device, 434
Operator panel, 475
Replacing
Automatic firmware update, 478
Control Interface Board (frame size FX), 448
Control Interface Board (frame size GX), 450
Control Interface Board (frame size HX), 452
Control Interface Board (frame size JX), 454
Error messages, 478
Fan (frame size HX), 460
Fan (frame size JX), 464
Operator panel battery, 475
Power block (frame size FX), 438
Power block (frame size GX), 440
Power block (frame size HX), 442
Power block (frame size JX), 446
Replacing components, 437
Replacing the Backup Battery of the Cabinet Operator
Panel, 475
Replacing the cabinet operator panel, 475
Residual risks, 18
Rotating measurement, 313
Runtime, 335
S
S5 – Selector for voltage/current AI0, AI1, 67
Saving the Parameters, Permanently, 242
Separate 24 V DC power supply for NAMUR (option
B02), 118
Service, 23
Service and Support, 428
Setpoint addition, 258
Setpoint channel, 258
Setpoint sources, 205
Analog inputs, 205
Fixed speed setpoints, 209
General information, 182
Motorized potentiometer, 207
Setting the PROFIBUS Address, 214
Settings for the infeed (Active Infeed) under difficult line
conditions, 308
Shield connection, 62
Signal connections, 62
Simulation operation, 336
Sine-wave filter (option L15), 72
Slip compensation, 270
SMC10, 98
Connection example, 100
SMC10 Sensor Module Cabinet-Mounted (option
K46), 98
SMC20, 102
Connection example, 104
SMC20 Sensor Module Cabinet-Mounted (option
K48), 102
SMC30, 106
SMC30 Sensor Module Cabinet-Mounted (option
K50), 106
SMC30: connection examples, 113