Operating instructions

Appendix
A.2 Parameter macros
Drive converter cabinet units
Operating Instructions, 10/2008, A5E00288214A
517
Parameter macro p0700 = 7: NAMUR (70007)
This macro is used to set the NAMUR terminal block as the default command source.
Table A- 4 Parameter macro p0700 = 7: NAMUR
Sink Source
Parameter Description DO Parameter Description DO
p0840[0] ON/OFF1 Vector r4022.0 TM31 DI0 TM31
p0844[0] No OFF2_1 Vector r4022.4 TM31 DI4 TM31
p0845[0] No OFF2_2 Vector r0722.3 CU DI3 CU
p0848[0] No OFF3_1 Vector r4022.5 TM31 DI5 TM31
p0849[0] No OFF3_2 Vector 1 Vector
p0806 Inhibit LOCAL mode Vector 0 Vector
p0810 Changeover CDS bit 0 Vector 0 Vector
p0852 Enable operation Vector 1 Vector
p0854 Control request Vector 1 Vector
p0922 PROFIdrive PZD telegram selection Vector 999 Free telegram configuration
p1020 FSW bit 0 Vector r4022.1 TM31 DI1 TM31
p1021 FSW bit 1 Vector r4022.2 TM31 DI2 TM31
p1035 MOP raise Vector r4022.1 TM31 DI1 TM31
p1036 MOP lower Vector r4022.2 TM31 DI2 TM31
p1113 Direction of rotation reversal Vector r4022.6 TM31 DI6 TM31
p1140 Enable RFG Vector 1 Vector
p1141 Start RFG Vector 1 Vector
p1142 Enable nsetp Vector 1 Vector
p2103 Acknowledge fault 1 Vector 0 Vector
p2104 Acknowledge fault 2 Vector r4022.3 TM31 DI3 TM31
p2106 Ext. fault_1 Vector r0722.1 CU DI1 CU
p2107 Ext. fault_2 Vector 1 Vector
p2112 Ext. alarm_1 Vector r0722.0 CU DI0 CU
p2116 Ext. alarm_2 Vector 1 Vector
p0738 DI/DO8 CU 1 +24 V CU
p0748.8 Invert DI/DO8 CU 0 Not inverted
p0728.8 Set DI/DO8 input or output CU 1 Output
p0739 DI/DO9 CU 1 +24 V CU
p0748.9 Invert DI/DO9 CU 0 Not inverted
p0728.9 Set DI/DO9 input or output CU 1 Output
p0740 DI/DO10 CU 1 +24 V CU
p0748.10 Invert DI/DO10 CU 0 Not inverted
p0728.10 Set DI/DO10 input or output CU 1 Output
p0741 DI/DO11 CU 1 +24 V CU
p0748.11 Invert DI/DO11 CU 0 Not inverted
p0728.11 Set DI/DO11 input or output CU 1 Output
p0742 DI/DO12 CU 1 +24 V CU