Operating instructions

Appendix
A.2 Parameter macros
Drive converter cabinet units
Operating Instructions, 10/2008, A5E00288214A
513
Sink Source
Parameter Description DO Parameter Description DO
p4056[0] Type of analog inputs TM31 2 Current 0...20 mA TM31
p4056[1] Type of analog inputs TM31 2 Current 0...20 mA TM31
p4076[0] Type of analog outputs TM31 0 Current 0...20 mA TM31
p4076[1] Type of analog outputs TM31 0 Current 0...20 mA TM31
p4071[0] Signal analog output 0 TM31 r0063 Actual speed smoothed TM31
p4071[1] Signal analog output 1 TM31 r0068 Absolute current actual value TM31
p4100 Type of temperature sensor TM31 0 (Factory setting) TM31
p4102[0] Alarm threshold, temperature
sensing
TM31 251 °C When this value is exceeded,
alarm A35211 is triggered.
TM31
p4102[1] Fault threshold for temperature
sensing
TM31 251 °C When this value is exceeded,
fault F35207 is triggered.
TM31
Parameter macro p0700 = 5: PROFIdrive (70005)
This macro is used to set the PROFIdrive interface as the default command source.
Table A- 2 Parameter macro p0700 = 5: PROFIdrive
Sink Source
Parameter Description DO Parameter Description DO
p0840[0] ON/OFF1 Vector r2090.0 PZD 1 bit 0 Vector
p0844[0] No OFF2_1 Vector r2090.1 PZD 1 bit 1 Vector
p0845[0] No OFF2_2 Vector r0722.3 CU DI3 CU
p0848[0] No OFF3_1 Vector r2090.2 PZD 1 bit 2 Vector
p0849[0] No OFF3_2 Vector r0722.2 CU DI2 CU
p0806 Inhibit LOCAL mode Vector 0 Vector
p0810 Changeover CDS bit 0 Vector 0 Vector
p0852 Enable operation Vector r2090.3 PZD 1 bit 3 Vector
p0854 Control request Vector r2090.10 PZD 1 bit 10 Vector
p0922 PROFIdrive PZD telegram selection Vector 999 Free telegram configuration
p1020 FSW bit 0 Vector 0 Vector
p1021 FSW bit 1 Vector 0 Vector
p1035 MOP raise Vector r2090.13 PZD 1 bit 13 Vector
p1036 MOP lower Vector r2090.14 PZD 1 bit 14 Vector
p1113 Direction of rotation reversal Vector r2090.11 PZD 1 bit 11 Vector
p1140 Enable RFG Vector r2090.4 PZD 1 bit 4 Vector
p1141 Start RFG Vector r2090.5 PZD 1 bit 5 Vector
p1142 Enable nsetp Vector r2090.6 PZD 1 bit 6 Vector
p2103 Acknowledge fault 1 Vector r2090.7 PZD 1 bit 7 Vector
p2104 Acknowledge fault 2 Vector r4022.3 TM31 DI3 TM31
p2106 Ext. fault_1 Vector r0722.1 CU DI1 CU
p2107 Ext. fault_2 Vector 1 Vector
p2112 Ext. alarm_1 Vector r0722.0 CU DI0 CU