Operating instructions

Operation
6.4 Command sources
Drive converter cabinet units
Operating Instructions, 10/2008, A5E00288214A
201
6.4.3 "NAMUR" default setting
Prerequisites
The NAMUR terminal block (option B00) is installed in the cabinet unit.
The "NAMUR" default setting was chosen during commissioning:
• STARTER:
"NAMUR"
• AOP30:
"7: NAMUR"
Command sources
U0DVWHUFRQWURODFWLYH
5(027(1$085WHUPLQDOEORFN
/2&$/2SHUDWRUSDQHO67$57(5
%XWWRQ/2&$/5(027($23
$VVXPHPDVWHUFRQWURO67$57(5
,QWHUQDOFRQWURO
2SHUDWRUSDQHO$23
&RQWUROSDQHO67$57(5
1$085WHUPLQDOV;
Figure 6-13 Command sources - AOP30←→NAMUR terminal block
Priority
The priority of the command sources is shown in the diagram "Command sources -
AOP30←→NAMUR terminal block".
Note
The EMERGENCY STOP and motor protection signals are always active (regardless of the
command source).
For LOCAL master control, all of the supplementary setpoints are deactivated.