Operating instructions

Commissioning
5.3 Procedure for commissioning via STARTER
Drive converter cabinet units
Operating Instructions, 10/2008, A5E00288214A
153
⇒ Under Command sources:, choose and Setpoint sources: choose the appropriate settings
for your device configuration.
The following command and setpoint source options are available:
PROFIdrive
TM31 terminals
NAMUR
Command sources:
PROFIdrive NAMUR
PROFIdrive
TM31 terminals
Motorized potentiometer
Setpoint sources:
Fixed setpoint
Note
With SINAMICS S150, only CDS0 is normally used as a default setting for the command and
setpoint sources.
Make sure that the selected default setting is compatible with the actual system
configuration.
Note
The choice "no selection" is also available as default setting for the command and setpoint
sources; if selected, no default settings are applied for the command and setpoint sources.
⇒ Check your default settings carefully and then click Continue >