User guide

LAN/Wi-Fi Configuration
Rev 1 Oct.13 95
Figure 4-27: ACEmanager: LAN > PPPoE
Configure the AirLink Device to Support PPPoE
Note: You must disable the DHCP server for PPPoE to work.
To configure an AirLink device to support PPPoE:
1. In ACEmanager, go to LAN > Ethernet.
2. Under General, in the DHCP Server Mode filed, select Disable.
Note: PPPoE authentication is optional. If you use PPPoE authentication, no other
tethered LAN connection will have network access, regardless of whether or not the
PPPoE host is connected. If you are using non-authenticated PPPoE, other tethered LAN
connections will have network access until a PPPoE host is connected.
3. If you want to use authenticated PPPoE:
a. Go to LAN > PPPoE, and in the Host Authentication Mode field, select
PAP and CHAP.
b. In the Host User ID, enter a user ID for the PPPoE connection.
Field Description
Host Authentication
Mode
Host Authentication Mode: Use PAP or CHAP to request the user login and password
during PPP or CHAP negotiation on the host connection. The username and password set
in *HOSTUID and *HOSTPW is used.
• NONE (Default)
• PAP and CHAP
• CHAP
Host User ID User ID for authentication (up to 64 bytes)
Host Password Password for authentication