User guide

ALEOS 4.3.4 Software Configuration User Guide
88 4114514
When the b/g Enabled option is selected from the Enable Wireless Access Point
field’s drop-down menu, and Open is selected in the WiFi Security Authentication
type field, an additional section for Open WEP appears:
Figure 4-23: ACEmanager: LAN/WiFi > Access Point Open WEP section
Bridge WiFi to
Ethernet
This field allows routing between the Ethernet Lan and WLAN. When enabled, the Ethernet
port and the Wi-Fi ports are on the same subnet. Available only when the Wi-Fi has its own
subnet (Bridge WiFi to Ethernet is disabled.) Options are:
• Enabled (Default)
• Disabled
DHCP
Host WiFi IP Displays the AP’s IP address. Default: 192.168.17.31
WiFi IP Start Displays the beginning IP address to be served. Default: 192.168.17.100
WiFi IP End Displays the ending IP address to be served. Default: 192.168.17.150
WiFi IP Netmask Displays the subnet IP netmask of the WiFi network. When this option is selected, the Wi-Fi
cannot be bridged to Ethernet. Default: 255.255.255.0
Advanced
Maximum Clients Indicates the maximum number of concurrent users (clients) to be supported. The
administrator specifies this number which can range from 1 to 8. Default: 8.
Transmit Power Adjusts the transmit power of the AP. Options are:
• High—High Power (16 dB) Default
• Low—Low Power (10 dB)
Field Description