User guide

LAN/Wi-Fi Configuration
Rev 1 Oct.13 75
Field Description
General
Ethernet Port Enabled or Disabled
Note: When the port is disabled, the device ignores any physical connection to the
Ethernet port.
Device IP The Ethernet IP address of the AirLink device. By default this is set to 192.168.13.31.
Starting IP Ethernet DHCP pool starting IP address
Note: If only one computer or device is connected directly to the Ethernet port, this is the
IP address it is assigned.
Ending IP The ending IP address for the Ethernet interface DHCP pool
DHCP network mask The Netmask given to any Ethernet DHCP client
DHCP Server Mode Enabled or disabled. By default, the Ethernet DHCP server is enabled. Disabling the
DHCP server requires all connected clients to have static IP addressing. Static IP hosts
need to be within the same subnet as defined by the device IP and DHCP network mask.
Advanced
Link Radio coverage to
Interface
This disables the specified port when there is no cellular coverage. Options are:
• Disable (default)
• Ethernet
• USB
Radio Link Delay
(seconds)
The delay in seconds before the selected interface goes down when there is no cellular
coverage
Interface Disabled
Duration
Sets the period of time (in seconds) that the LAN interface is disabled when linking a LAN
port to radio coverage. Either the Ethernet or the USB LAN port can be linked to the radio
coverage, but not at the same time. Options are:
• Interface Disabled when Radio is disconnected (Default)
• 5 Sec
• 10 Sec
• 15 Sec
• 20 Sec
• 25 Sec
• 30 Sec
Turn Off NAT When enabled, ALEOS routes packets without performing NAT on them. Options:
Disabled (default) and Enabled.