User guide

Rev 1 Oct.13 383
ALEOS Application Framework (ALEOS AF)
I’m unable to load an application from ALEOS AF.
1. In ACEmanager, go to Services > Telnet/SSH.
2. In the AT Server Mode field, select Telnet.
3. Click Apply.
4. Re-try loading the application from ALEOS AF.
SMS
I tried to send an SMS message, and received an error code. What
does the error code mean?
The following acknowledgment error codes may appear if your message was not
successfully sent:
Code:
Explanation:
100 Not in coverage (no cellular service)
201 Parse Error on field #1 (Start Field)
202 Parse Error on field #2 (Phone number and separator)
203 Parse Error on field #3 (Data type and separator)
204 Parse Error on field #4 (Payload length and separator)
205 Parse Error on field #5 (Message and End Field)
301 No buffers available
302 SMS queue full
Supported SMS data types are ASCII, 8-bit, and Unicode, and are all case-
sensitive. SMS messages being sent MUST be in ASCII hex format.
I tried to send an SMS command and received the error “not set”.
The parameter was not changed.
Check the format of the SMS command. There should be no space between the
prefix and the command (or the 1st command parameter in the case of multi-
parameter commands), and a single space between all other fields to act as a
delimiter. For more information, see SMS Commands on page 377 and SMS on
page 157.
GPS
I set the GPS Reports Port field on the GPS > Local Streaming
window to stream GPS data to a USB port, but I don't see GPS data
on the USB port.
The GPS streaming feature works with serial devices. To stream data to a USB
port, you must first configure the USB port to act as a serial device.