User guide

ALEOS 4.3.4 Software Configuration User Guide
382 4114514
If you have a network with multiple LAN hosts that are sending data to the same
server and the server is not receiving data from one (or more) of the hosts, it may
be because the Mobile Network Operator has a WAN firewall that is blocking the
ports used by the NAT for over-the-air (OTA) destinations.
To correct this problem:
1. Launch ACEmanager.
2. Go to the LAN/WiFi tab.
3. Select Ethernet.
4. Refer to the instructions for setting the Starting Ephemeral Port on page 76.)
Wi-Fi
My GX Series device has a Wi-Fi X-Card installed, and I have it
configured to act as an access point, but I don’t see an option to use
WEP encryption.
1. Launch ACEmanager.
2. Go to the LAN/WiFi tab.
3. Select WiFi.
4. In the Enable Access Point field, change the value from “b/g/n Enabled” to “b/
g Enabled”.
Once this change is made, an “Open WEP” section appears below the WiFi
Configuration section.
WEP encryption is only supported on 802.11b and 802.11g. It is not supported on
802.11n.
Port Forwarding
I set up port forwarding rules. I did not receive an error message, but
it seems that data is not being forwarded.
If the Public Start Port and Public End Port fields are not set up correctly, data is
not forwarded.
1. In ACEmanager, go to Security > Port Forwarding.
• If you are forwarding data to a single port:
· Ensure that the value in the Public Start Port field is not 0.
· Ensure that the value in the Public End Port field is 0.
· Ensure that the value in the Private Port start field is not 0.
• If you are forwarding data to a range of ports:
1. Ensure that the value in the Public Start Port field is not 0.
· Ensure that the value in the Public End Port field is greater than the value in
Public Start Port field.
· Ensure that the value in the Private Port Start field is not 0.
For complete instructions, see Port Forwarding on page 133.