User guide

ALEOS 4.3.4 Software Configuration User Guide
358 4114514
*PPPORT
*PP2PORT
*PP3PORT
*PP4PORT
Query or set the port GPS reports are sent to.
AT*PP[Server number if other than server 1]PORT? to query
AT*PP[Server number if other than server 1]PORT=n to set
• n=0—Disable
• n=1–65535
*PPREPORTINPUTS
*PP2REPORTINPUTS
*PP3REPORTINPUTS
*PP4REPORTINPUTS
Query or set input reporting and including the current digital input value in RAP reports.
AT*PP[Server number if other than server 1]REPORTINPUTS? to query
AT*PP[Server number if other than server 1]REPORTINPUTS=n to set
• n=0—Disabled
• n=1—Enabled
*PPSIMPLETO
*PP2SIMPLETO
*PP3SIMPLETO
*PP4SIMPLETO
Query or set the first retry interval for Simple Reliable, UDP Sequence mode, and TCP
transports (in seconds).
AT*PP[Server number if other than server 1]SIMPLETO? to query
AT*PP[Server number if other than server 1]SIMPLETO=n to set
• n=0—Disable
• n=1–255 (Default is 10.)
*PPSNF
*PP2SNF
*PP3SNF
*PP4SNF
Query or set the Store and Forward (SNF) setting. SNF causes GPS reports to be stored if
the device/vehicle goes outside the area of network coverage. Once the vehicle is in the
coverage area, the GPS reports are sent en masse to the server.
AT*PP[Server number if other than server 1]SNF? to query
AT*PP[Server number if other than server 1]SNF=n to set
• n=0—Disabled
• n=1—Enabled (default)
*PPSNFR
*PP2SNFR
*PP3SNFR
*PP4SNFR
Query or set Transport /SNF mode. GPS reports are retransmitted if not acknowledged by
the server.
AT*PP[Server number if other than server 1]SNFR? to query
AT*PP[Server number if other than server 1]SNFR=n to set
• n=0—Disabled
• n=1—Reliable mode
• n=2—Simple Reliable mode
• n=3—UDP Sequence
• n=4—TCP Listen
•n=5—TCP
*PPTAIPID Query or set the four character alphanumeric TAIP ID.
AT*PPTAIPID? to query
AT*PPTAIPID=nnnn to set
• nnnn=alphnumeric characters
Table D-9: GPS AT Commands (Continued)
Command Description