User guide

ALEOS 4.3.4 Software Configuration User Guide
356 4114514
*PPGPSR
*PP2GPSR
*PP3GPSR
*PP4GPSR
Query or set the GPS report type.
AT*PP[Server number if other than server 1]GPSR? to query
AT*PP[Server number if other than server 1]GPSR=n to set
RAP reports:
• n=0 — Use legacy reports specified in *MF value. Note: Must also have *PPDEVID=0.
• n=11 — Standard GPS Report
• n=12 — Standard GPS Report + UTC Date
• n=13 — Standard GPS Report + UTC Date + RF data
• n=14—Standard GPS report + GPS + Date + RF + EIO
Xora reports
•n=D0 — Xora
NMEA reports
• n=E0 — GGA and VTG NMEA reports
• n=E1 — GGA, VTG and RMC NMEA reports
• n=E2 — GGA, VTG, RMC, GSA and GSV NMEA reports
TAIP reports
• n=F0 —TAIP data—TAIP GPS report that contains position and velocity
• n=F1 —TAIP GPS report that contains the compact position
• n=F2—TAIP LN report—TAIP GPS report that contains a long navigation message
• n=F3—TAIP TM report—TAIP GPS report that contains the time and date
*PPINPUTEVT
*PP2INPUTEVT
*PP3INPUTEVT
*PP4INPUTEVT
Query or set ability to send a special report for digital input changes.
AT*PP[Server number if other than server 1]INPUTEVT? to query
AT*PP[Server number if other than server 1]INPUTEVT=n to set
• n=0 — Disable
• n=1 — Enable
*PPIP
*PP2IP
*PP3IP
*PP4IP
Query or set the IP address where GPS reports are sent. See also *PPPORT on page 358.
AT*PP[Server number if other than server 1]IP? to query
AT*PP[Server number if other than server 1]IP=d.d.d.d to set
• d.d.d.d=IP address
Example:
AT*PPIP=192.100.100.100
*PPLATS Query or set the local reporting interval (in seconds).
AT*PPLATS? to query
AT*PPLATS=n to set
• n=0—Disable (default)
• n=1–255 (seconds)
*PPLATSEXTRA Query or set the number of additional consecutive ports that the local GPS report is sent to.
AT*PPLATSEXTRA? to query
AT*PPLATSEXTRA=n to set
• n=0—Just the original report is sent (default).
• n=1–7—Send GPS report copies to that number of ports.
Example: If AT*PPLATSEXTRA=7 and the port in S53 is 1000, then GPS reports will be
sent to ports 1000–1008.
Table D-9: GPS AT Commands (Continued)
Command Description