User guide

ALEOS 4.3.4 Software Configuration User Guide
354 4114514
*PGPSD Query or set the delay (in seconds) before the out-of-coverage stream begins sending the
messages out the serial port and not into SnF.
AT*PGPSD? to query
AT*PGPSD=n to set
• n=0 (default)
• n=1–255
Note: Any messages put into SnF during this switch-over delay period are sent over the air
when coverage is re-acquired.
Note: The two persistent GPS report parameters, *PGPSR and *PGPSF, control the report
type and message frequency of reports sent out the serial port when the AirLink device is
out of cellular network coverage.
*PGPSF Query or set how frequently (in seconds) the GPS report is sent to the serial link.
AT*PGPSF? to query
AT*PGPSF=n to set
• n= 0–65535
*PGPSR Query or set the GPS report type.
AT*PGPSR? to query
AT*PGPSR=n to set
NMEA reports:
• n=E0—NMEA GGA + VTG
• n=E1—NMEA GGA+VTG+RMC
• n=E2—NMEA GGA+VTG+RMC+GSA+GSV
TAIP reports:
•n=F0—TAIP data
• n=F1—TAIP compact data
• n=F2—TAIP LN report
• n=F3—TAIP TM report
*PPDIST
*PP2DIST
*PP3DIST
*PP4DIST
Query or set the GPS report distance interval in 100 meter units. For example, if you
entered a value of 635, it would translate to 63,500 meters (63.5 kilometers).
AT*PP[Server number if other than server 1]DIST? to query
AT*PP[Server number if other than server 1]DIST=n to set
• n=0 — Disabled
• n=1–65535 — Distance in 100 meter units that the device moves before sending a
GPS report
Table D-9: GPS AT Commands (Continued)
Command Description