User guide

Rev 1 Oct.13 349
*SMS_PASSWORD Query or set the SMS password.
AT*SMS_PASSWORD? to query
AT*SMS_PASSWORD = n
n= SMS password
If no password has ever been configured, a default password is created from the
last four characters of the SIM ID (for all SIM-based devices) or the ESN (for
devices without a SIM, such those using EV-DO).
Note: The configured password remains in place, even when the device is reset to
factory default settings.
*SMSWUPTOUT HSPA only
Query or set the connection timeout for the SMS Wakeup feature. When this feature
is enabled, an IP connection is initiated on receipt of a specific type of SMS. The
IP connection closes after the timeout period specified in this AT command.
Outgoing traffic sent after the timer is set does not reset the timer.
AT*SMSWUPTOUT? to query
AT*SMSWUPTOUT=n to set
• n=2–65535 minutes (default is 2)
See also *RADIO_CONNECT on page 333.
Telnet/SSH
*TELNETTIMEOUT Query or set the Telnet/SSH idle time out.
By default, this value is set to close the telnet/SSH connection if no data is received
for 2 minutes.
AT*TELNETTIMEOUT? to query
AT*TELNETTIMEOUT=n to set
• n=1—255 minutes (Default is 2.)
*TSSH Query or set the remote login server mode.
AT*TSSH? to query
AT*TSSH=n to set
• n=0—Telnet (default)
• n=1—SSH
*TPORT Query or set the Telnet/SSH port.
AT*PORT? to query
AT*PORT=n to set
• n=1–65535 (Default is 2332.)
Many networks have the ports below 1024 blocked. It is recommended to use a
higher numbered port.
Management (SNMP)
SNMP General Configuration
Table D-8: Services AT Commands
Command Description