User guide

Rev 1 Oct.13 347
*IPMANAGER1
*IPMANAGER2
Note: This AT command is only usable if the Dynamic DNS Service type is set to IP
Manager.
Query or set a FQDN or IP address of the IP server to send IP change notifications
to. You can configure two independent IP Manager servers.
AT*IPMANAGER[n]? to query
AT*IPMANAGER[n]=SERVER to set.
• n=1—First IP Manager server
• n=2—Second IP Manager server
• SERVER = Server FQDN or IP address
Note: You can disable updates to a server by setting blank entry
(e.g., “AT*IPMANAGER1=”).
*IPMGRKEY1
*IPMGRKEY2
Note: This AT command is only usable if the Dynamic DNS Service type is set to IP
Manager.
Query or set the 128-bit password/key used to authenticate the IP update
notifications. If the key's value is all zeros, a default key is used. If all the bytes in
the key are set to FF, then no key is used (i.e., the IP change notifications will not be
authenticated).
AT*IPMGRKEY[n]? to query
AT*IPMANAGER[n]=KEY to set
• n=1—First IP Manager server
• n=2—Second IP Manager server
• KEY=128-bit key in hexadecimal [32 hex characters]
*IPMGRUPDATE1
*IPMGRUPDATE2
Note: This AT command is only usable if the Dynamic DNS Service type is set to IP
Manager.
Query or set the interval (in minutes) to send an IP update notification to the
corresponding server. This occurs even if the IP address of the device does not
change. If the value is set to 0, then periodic updates are not issued (i.e., IP change
notifications is only be sent when the IP actually changes).
AT*IPMGRUPDATE[n] to query
AT*IPMGRUPDATE[n]=INTERVAL to set
• n=0—Disables the update interval (updates only on changes)
• n=1—First IP Manager server
• n=2—Second IP Manager server
• INTERVAL=1–255—interval (in minutes) to send an update
Table D-8: Services AT Commands
Command Description