User guide

ALEOS 4.3.4 Software Configuration User Guide
338 4114514
*APTXPWR Query or set the Wi-Fi Access Point Transmit Power mode.
AT*APTXPWR? to query
AT*APTXPWR=n to set
• n=0—Low
•n=1—Normal
*APWEPENCTYPE? Query the Wi-Fi Access Point WEP encryption type.
AT*APWEPENCTYPE?
• n=0—Disabled (Open)
•n=1—WEP
Note: WEP is not a recommended Wi-Fi Security protocol because of its vulnerabil-
ities and because only alphanumeric characters can be used for the passphrase.
Use WPA/WPA2 instead.
*APWEPKEY? Query the Wi-Fi Access Point WEB key generated at boot from the WEP
passphrase.
AT*APWEPKEY?
*APWEPKEYLEN? Query the length of the Wi-Fi Access Point WEP key.
AT*APWEPKEYLEN?
• n=0—64-bit
• n=1—128-bit
•n=2—Custom
*APWPACRYPT? Query the Wi-Fi Access Point WPA/WPA2 encryption type.
AT*APWEPKEY?
•n=0—TKIP
• n=1—AES
Note: If you are using WPA2, only AES is allowed.
WCC? Query the Wi-Fi country code.
*WIFIMAC? Query the MAC address of the Wi-Fi Access Point.
Note: Wi-Fi Client uses a different MAC address.
*WIFIMODE Query or set the WI-Fi Mode.
AT*WIFIMODE? to query
AT*WIFIMODE=n to set
• n=0—Disabled
• n=1—AP (Access Point)
•n=2—Client
• n=3—AP and Client
For more information, see Wi-Fi on page 85.
Table D-5: Wi-Fi AT Commands (Continued)
Command Description