User guide

ALEOS 4.3.4 Software Configuration User Guide
336 4114514
Wi-Fi
Wi-Fi AT Commands are only applicable if the AirLink device has an installed
Wi-Fi X-Card and is in Access Point Mode.
Note: You need to configure Client Mode in ACEmanager. There is no AT Command for
Wi-Fi Client mode. See WiFi Mode on page 72.
Note: A reboot is required before these commands take effect.
*HOSTUID Query or set the Host user ID for PPPoE only. (It does not set the user ID for PPP/DUN.)
AT*HOSTUID? to query
AT*HOSTUID=USER ID to set (up to 64 bytes)
Note: USER ID cannot be “user”.
*USBDEVICE Query or set the USB Device Mode.
This parameter alters the default startup data mode.
AT*USBDEVICE? to query
AT*USBDEVICE=n to set
•n=0—USB Serial
• n=1— USBNET
• n=2— Disabled
Table D-4: LAN AT Commands (Continued)
Command Description
Table D-5: Wi-Fi AT Commands
Command Description
*APBRIDGED Query or set the Bridge Wi-Fi Access Point to Ethernet feature.
AT*APBRIDGED? to query
AT*APBRIDGED=n to set
• n=0 —Disable
• n=1 —Enable
*APCHANNEL Query or set the Wi-Fi Access Point channel to use.
AT*APCHANNEL? to query
AT*APCHANNEL=n to set
• n = 1 – 11 (available channels)
*APEN Query or set the Wi-Fi Access Point mode.
AT*APEN? to query
AT*APEN=n to set
• n=2 —b/g Enabled
• n=3 —b/g/n Enabled