User guide

Rev 1 Oct.13 329
+CGDCONT HSPA only
Query or set the PDP context, APN, and other information required to establish a
connection to o an HSPA network. You only need to configure this once. The parameters
are saved and used each time a connection is made to the HSPA network.
AT+CGDCONT? to query
AT+CGDCONT = PID,PDP_TYPE,APN [,IPADDR] to set
PID= PDP context identifier
PDP_TYPE = numeric parameter that specifies a PDP context definition
APN = Access Point Name
IPADDR = IP address
Examples:
AT+CGDCONT=1,IP,proxy
AT+CGDCONT=1,IP,internet
Note: When using the APN-related optons in ACEmanager, you generally do not need to
configure +CGDCONT.
*CLIENT_PPP_AUTH Query or set the Force Network Authentication mode.
AT*CLIENT_PPP_AUTH? to query
AT*CLIENT_PPP_AUTH=n to set
• n=0—None
•n=1—PAP
• n=2—CHAP
+COPS HSPA only
Query or set the network operator and the connection mode.
AT+COPS? to query
AT+COPS=MODE[,FORMAT[,OPER]] to set
MODE
• MODE=0 — Automatic (default)
• MODE= 1 — Manual
• MODE=4 — Manual/Automatic; if manual failed, it defaults to automatic
FORMAT
• FORMAT=0 — Alphanumeric (“Name”)
• FORMAT=2 — Numeric
OPER
• OPER= the operator numeric code
Example, AT+COPS=1,2,302610
Manual mode, numeric format, operator code 302610
Note: On some cellular networks, explicit use of +COPS allows you to select the roaming
Mobile Network Operator to use.
Table D-3: WAN/Cellular AT Commands
Command Description