User guide

ALEOS 4.3.4 Software Configuration User Guide
324 4114514
*ETHMAC? Query the MAC address of the Ethernet port
• AT*ETHMAC? — Returns the MAC address of the main Ethernet port
If you have a GX Series device with a Dual Ethernet X-Card installed:
• AT*ETHMAC?2 — Returns the MAC address of the Ethernet X-Card port marked eth2
• AT*ETHMAC?3 — Returns the MAC address of the Ethernet X-Card port marked eth3
*ETHSTATE? Query the connection state (speed and duplex) of the Ethernet port.
• AT*ETHSTATE? — Returns the speed and duplex state of the main Ethernet port (e.g.
100Mb/s Full Duplex)
If you have a GX Series device with a Dual Ethernet X-Card installed:
• AT*ETHSTATE2? — Returns the speed and duplex state of the Ethernet X-Card port
marked eth2
• AT*ETHSTATE3? — Returns the speed and duplex state of the Ethernet X-Card port
marked eth3
*GLOBALID? Query the global ID used by AVMS to identify the device.
*HOSTCOMMLVL? Query the serial host signal level.
Response example: DCD:LOW; DTR:LOW; DSR:HIGH; CTS:HIGH; RTS:LOW
+HWTEMP? Query the internal temperature of the radio module (in degrees Celsius).
I[n] Query device information.
• n omitted—device model
• n=0—device model
• n=1—ALEOS software version, hardware revision, boot version
• n=2—Radio module firmware version
• n=3—Radio module’s unique ID (ESN, IMIEI, or EID)
+ICCID? HSPA and LTE only.
Query the SIM ID.
*LTERSRQ? LTE only
Query the LTE signal quality (in dB).
For more information, see LTE Signal Quality (RSRQ) on page 45.
*LTERSRP? LTE only
Query the LTE signal strength (in dBm).
For more information, see LTE Signal Strength (RSRP) on page 44.
*NETCHAN? Query the current cellular network channel.
Table D-2: Status AT Commands (Continued)
Command Description