User guide

Rev 1 Oct.13 323
Device Updates
Status
Table D-1: Device Update AT Commands
Command Description
*TPLUPDATE This AT command updates templates (configuration files) remotely.
The template files must be accessible on an FTP server.
The command parameters are:
AT*TPLUPDATE=Server_IP,USER_NAME,PASSWORD,FILE_NAME
where:
• SERVER_IP is the IP address of the FTP server.
• USER_NAME is the user name used to access the FTP server.
• PASSWORD is the password used to access the FTP server.
• FILE_NAME is the name of the template file on the FTP server that you want to apply
to the AirLink device. The must be stored on the FTP User_Name home, not in a sub-
folder.
Example:
AT*TPLUPDATE=192.168.17.111,MyUserName,MyPassword,NewTemplate.xml
When the template is successfully applied, the message displayed is:
Template applied successfully
OK
Table D-2: Status AT Commands
Command Description
*BAND? HSPA and LTE fallback to HSPA only.
Query the current radio module band.
*CELLINFO? Query cellular connection information.
*CELLINFO2? Query in depth cell information.
+CIMI? HSPA and LTE only.
Query the IMSI.
*DEVICEID? When the device is configured to use the device ID with GPS reports, this command
displays the 64-bit device ID created from the ESN/IMEI or phone.
Note: If the device is not configured to use the device ID with GPS reports, the command
returns “NOT SET”.
*DNS1?
*DNS2?
Query the primary DNS (*DNS1) and secondary (*DNS2) IP addresses.
AT*DNS1? to query DNS1
AT*DNS2? to query DNS2
+ECIO? Query the signal quality.