User guide

Admin
Rev 1 Oct.13 265
Figure 14-4: ACEmanager: Admin > Log, Configure Logging
2. For each subsystem listed:
a. Select whether or not to display it in the log.
Separate filters, based on subsystem and severity, are applied when the mes-
sages are generated and when the messages are displayed. Four severity
levels are supported for filtering in the drop-down lists for verbosity:
· Critical
· Error
· Info (information)
· Debug
Note: The VPN Sub System only allows for Info and Debug. For maximum information, set
the VPN verbosity to Debug.
b. Select the verbosity level.
Note: Some log messages are only displayed if you display Linux Syslog. For example, If
you are debugging a VPN or LAN setup, the relevant information is only displayed in the
Linux Syslog.
3. Optional: To display Linux Syslog:
a. Ensure that Display (default value) is selected the drop-down menu
beside Linux Syslog.
4. Click Apply.
5. If you have changed any of the verbosity levels or the Linux syslog setting:
a. Reboot the AirLink device.