User guide

I/O Configuration
Rev 1 Oct.13 257
Configuration
This screen allows you to configure the initial relay settings and to transform units
of measurement for the analog inputs from volts to a more appropriate unit, if
applicable. Generated reports use the transformed value configured on this
screen.
Refer to the user guide for your AirLink products for pinout information.
Figure 13-2: ACEmanager: I/O > Configuration
Field Description
Relay # Initial Setting The initial relay value when the AirLink device is powered on
Options are:
• ON
• OFF (default)
• Last Value (The value remains the same as it was before the AirLink device was
powered down).
When you change this field, the corresponding digital input value on this screen reflects
the change after a screen refresh.
Coefficient for
Analog #
This value may be found in the user guide for the equipment you want to monitor, or you
can calculate it from information in the user guide. If this information is not available in the
documentation that came with the equipment you want to monitor, contact the
manufacturer.
For an example of how to calculate the coefficient, see Transformed Analog on page 258.