User guide

ALEOS 4.3.4 Software Configuration User Guide
254 4114514
You can use Events Reporting to generate reports and actions based on the
digital input values.
Relay outputs
You can use relay outputs to trigger an intermediary switch and change the state
of equipment.
AirLink GX Series device
The AirLink GX Series device without the I/O X-Card installed:
• Has one digital input or one relay output (configurable)
• Does not support analog input
The AirLink GX Series device with the I/O X-Card installed has:
• Five digital inputs or five relay outputs (configurable)
• Four analog inputs
Note: The fields for configuring the additional digital inputs/relay outputs are only available
if you have an AirLink GX Series device with an I/O X-Card installed.
LS300
The LS300 has one pin that can be used as a digital input, relay output, or analog
input.
More information
For more information on the basic features of the I/O settings for your AirLink
device, refer to the applicable AirLink device user guide.
For more information on setting up reports, see Events Reporting Configuration
on page 207.
Note: Changes to the relay outputs go into effect immediately. No reboot of the AirLink
device is necessary. A reboot is required after configuring the transformed analog values.
(See Transformed Analog on page 258.)
Volts Interpreted as
-0.5 –1.2 Digital 0
2.2 – 30 Digital 1