User guide

ALEOS 4.3.4 Software Configuration User Guide
236 4114514
Figure 11-7: ACEmanager: Serial > IO X-Card Serial Port > IO X-Card Serial Configuration
Table 11-6: Serial > IO X-Card Serial Port > IO X-Card Serial Configuration
Field
Description
Startup Mode Default The default startup mode for the serial port
Options are:
• Normal (AT command) default
• UDP
• TCP
You can also use an AT command to configure this field. See MD on page 361.
Configure Serial Port Format: [speed],[data bits][parity][stop bits]
Valid speeds are 300–115200, data bits: 7 or 8, parity: O,E,N,M, stop bits: 1,1.5,2
• 115200, 8N1 (default)
You can also use an AT command to configure this field. See S23 on page 370.
Flow Control Serial port data flow control setting
• None—No flow control is being used (default)
• Hardware—RTS/CTS hardware flow control is being used
• Transparent SW—Transparent software flow control. Uses escaped XON and
XOFF for flow control. XON and XOFF characters in data stream are escaped with
the @ character (0x40). @ in data is sent as @@.
You can also use an AT command to configure this field. See \Q on page 369.