User guide

ALEOS 4.3.4 Software Configuration User Guide
230 4114514
TCP
Figure 11-3: ACEmanager: Serial > Port Configuration > TCP
Keep Alive Mode When this feature is enabled, the AirLink device reboots if there is no traffic for longer than
the period configured in the Keep Alive Delay field. Options are”
• Disable (default)
• Enable
Keep Alive Delay When Keep Alive Mode is enabled, use this field to set the delay (in minutes) before the
AirLink device reboots if there is no traffic on the serial port. Accepted values:
• 10–65535
Table 11-2: Serial Port Configuration > Advanced
Field Description
Table 11-3: Serial Port Configuration > TCP
Field Description
TCP
TCP Auto Answer This determines how the AirLink device responds to an incoming TCP connection request.
The AirLink device remains in AT Command mode until a connection request is received.
The AirLink device sends a “RING” string to the host. A “CONNECT” sent to the host
indicates acknowledgment of the connection request and the TCP session is established.
• Disable (default)
• Enable
You can also use an AT command to configure this field. See S0 on page 369.