User guide

Serial Configuration
Rev 1 Oct.13 227
Note: You may be required to enter a user name and password to access the router or
other device.
UDP Multiple Unicast
With UDP Multiple Unicast, data from the serial port is packed into UDP packets
and sent to multiple IP addresses. To configure UDP Multiple Unicast:
1. Log in to ACEmanager as “user” and go to Serial > Port Configuration > Port
Configuration.
2. In the Startup Mode Default field, select UDP Multiple Unicast.
3. In the Destination Port field, enter the remote port to be used.
4. Click Apply.
5. Go to Serial > Modbus Address List and enter the index numbers and IP
addresses of the devices you want the data sent to. (See Modbus Address
List on page 234.)
6. Click Apply.
7. Reboot the device.
Note: To avoid flooding the network, there is a 20 millisecond pause between sending the
UDP packet to each destination.