User guide

Serial Configuration
Rev 1 Oct.13 225
To configure Reverse Telnet/SSH:
1. Log into ACEmanager and go to Serial > Port Configuration.
2. In the Startup Mode Default field, select Reverse Telnet/SSH and click Apply.
3. In the Configure Serial Port field, set the speed, data bits, parity, and stop
bits. (The serial port configuration depends on the router you want to connect
to. For example, to connect to a Cisco router that has a default baud rate of
9600, enter 9600,8N1 in the Configure Serial Port field.)
4. Optional—If you are planning to use telnet (rather than SSH), you can be
automatically logged in when you telnet to the AirLink device without having
to enter a user name and password. Autologin is not supported with SSH.
To set up automatic login:
a. In the Autologin Reverse Telnet field, select Enable.
b. Click Apply.
5. Go to Services > Telnet/SSH.
6. In the Remote Login Server Mode field, select:
· Telnet—if you want to Telnet into the connected device
· SSH—if you want to SSH into the connected device
Note: If you enabled Autologin, select Telnet.