User guide

Events Reporting Configuration
Rev 1 Oct.13 217
By default, all the boxes are clear.
Figure 10-13: ACEmanager: Events Reporting > Action (for GX Series device with an I/O X-Card
installed)
The reports attributes are:
• Digital and Analog I/O
The options available in this section depend on the AirLink device, and in the
case of the AirLink GX Series device, whether or not it has an I/O X-Card
installed.
· Enable for Digital Inputs 1–5—The status of the specific digital inputs
· Enable for Digital Outputs 1–5—The status of the specific digital outputs
· Enable for Pulse Accumulator 1–5—The pulse count of the specific digital
inputs
· Enable for Analog Inputs 1–5— The status of the specific analog input
(reported in volts)
· Enable for Transformed Analog Inputs 1–5— The status of the specific
analog input (reported in units configured in ACEmanager I/O >
Configuration—see Configuration on page 257)
• AVL
· Enable for Satellite Fix—Whether or not there is a usable GPS satellite fix
· Enable for Latitude—The latitude reported by GPS
· Enable for Longitude—The longitude reported by GPS