User guide

Device Configuration
Rev 1 Oct.13 21
Figure 2-6: ACEmanager: Select and Upload Template
4. Click Upload File to Modem.
5. Click Load Template. As in the template creation process, there is a time
delay as the template uploads.
Note: If you are uploading a large template, you may see pop-up windows referring to a
script error. This is a time-out error. Retry once or twice before stopping the script and
reloading the template.
Tip: After you load the template, it’s best to go back over the ACEmanager tabs to make
sure all the settings are what you require. Red asterisks (*) appear on the tabs that have
been changed. Make any adjustments to the settings as needed.
6. Click the Apply button on the toolbar to write the configuration to the device.
7. Click OK.
8. Click the Reboot tab to reset the device.
Caution: Many configuration settings do not take effect until the device has been reset.
Tip: Use the common settings on one device to configure the same settings on another
device. For example, use the serial settings on one device to configure these settings on
another device.