User guide

ALEOS 4.3.4 Software Configuration User Guide
206 4114514
Advanced
TCP GPS Port You can obtain a single location snapshot from the device via a TCP session using the
AirLink device’s IP address and the device port configured in this field.
• 1–65535 (default 9494)
• 0 = Disable
You can also use an AT Command to set this value. For more information, see
*PPTCPPOLL on page 359.
Note: Access is restricted to the IP address defined for server 1. (See Report Server IP
Address on page 192.)
GPS Fix Mode Specifies the GPS fix mode. Options are:
• Standalone (default)
• MS Based—(Mobile Station Based fix) Uses assistance GPS data from a remote
server over the WAN interface
Heading Sensitivity Sets the sensitivity of the GPS heading reading
• Normal (default)
• High
It is recommended that you leave the field set to Normal to avoid showing misleading
heading values from poor GPS signal (poor sky view, reflections in urban canyon, etc.), but
if your GPS application has its own GPS heading sensitivity algorithms, try changing this
setting to High.
Table 9-4: GPS: Global Settings (Continued)
Field Description