User guide

ALEOS 4.3.4 Software Configuration User Guide
196 4114514
Redundant Servers
When one or two redundant servers are enabled, each time a message is sent
out to the main server a second identical message is sent to the redundant
server(s).
The redundant servers can be running the same or different application than the
primary server. The messages to the redundant server are independent of the
primary server settings or state.
You can configure one or both redundant servers. The messages are sent
independently to either or both.
Note: Messages are sent whether or not the server is available and do not use any reliable
mode format. Receipt of a message is not acknowledged nor is any message resent.
Messages to redundant servers are in UDP only.
GPS RAP Report Sequence Example
In this example:
The AirLink device is installed in a police car.
• Digital input 2 is connected to the switch that controls the siren.
• Digital input 3 is connected to the laptop docking station.
ACEmanager has the following configuration:
• Report Interval Time: 30 seconds
• Report Interval Distance: 150 meters
• Stationary Vehicle Timer: 5 minutes
• Send Stationary Vehicle Event in Seconds: 6 seconds
• Maximum Speed Event: 100 km/h
• Enable Digital Input Event: Enable
• Report Type: GPS + Date (RAP GPS report type 0x12)
• Low Power Mode: Low Voltage (See Services > Low Power on page Low
Power on page 147.)
Report Odometer Enables odometer reporting. Options are:
• Disable (default)
• Enable
You can also use an AT Command to set this value. For more information, see *PPODOM
on page 357.
Report Digital Inputs Enables digital input reporting. Options are:
• Disable (default)
• Enable
You can also use an AT Command to set this value. For more information, see
*PPREPORTINPUTS on page 358.
Table 9-1: GPS: Servers 1–4
Field Description