User guide

ALEOS 4.3.4 Software Configuration User Guide
190 4114514
Send Stationary
Vehicle Event in
Seconds
A GPS report is sent if the vehicle (or device) has been in one location for more than the
specified time (in seconds) and again when the vehicle (or device) moves from that
location. Options are:
• 1–255
• 0 = Disables sending GPS reports based on a vehicle being stationary (default)
Note: If you are using one of the RAP GPS report types (see GPS Report Type on
page 191) the GPS report triggered by this feature includes:
• A marker to indicate that it was triggered by the vehicle either being stationary or
starting to move again
• The standard GPS information for the configured report type
For more information, refer to the RAP Protocol Guide.
If you are not using a RAP GPS report, a standard report is sent.
You can configure Stationary Vehicle Event in Seconds and Stationary Vehicle Timer
together to receive a special report when the device is stationary longer than x seconds, a
normal report every x minutes it is stationary (instead of the Report Interval Time) and a
special report when the vehicle begins moving again.
Enable Digital Input
Event
A GPS report is sent if the configured digital input changes. For example, this could be
used to trigger a report being sent when an emergency light or siren is turned on or off, or
when a door is opened or closed. The GPS data in the report informs you of where the
event took place.
Options are:
• Disable (default)
• Enable
Note: If you are using one of the RAP GPS report types (see GPS Report Type on
page 191) the GPS report triggered by this feature includes:
• A marker to indicate that it was triggered by a change in status of the configured digital
input
• The standard GPS information for the configured report type
For more information, refer to the RAP Protocol Guide.
If you are not using a RAP GPS report, a standard report is sent.
You can also use an AT Command to set this value. For more information, see
*PPINPUTEVT on page 356.
Table 9-1: GPS: Servers 1–4
Field Description