User guide

ALEOS 4.3.4 Software Configuration User Guide
134 4114514
Single port
To define a port forwarding rule for a single port:
1. In ACEmanager, go to Security > Port Forwarding.
Figure 7-2: ACEmanager: Security > Port Forwarding (Single Port)
2. In the Port Forwarding Enabled field, select Enable.
3. Click “Add More” to display a rule line.
4. In the Public Start Port field, enter the desired public network port number.
Values between 1 and 65535 are supported, although Sierra Wireless recom-
mends using a value greater than 1024.
Unsolicited data coming in on this port is forwarded to the port you select in
the Private Start Port field.
5. In the Public End Port field, enter 0.
6. Select the desired protocol (see Protocol on page 136):
· TCP
· UDP
· TCP & UDP
7. Enter the IP address of the computer you want to forward data to.
8. In the Private Start Port field, enter the number of the port on the destination
computer that you want to forward data to.
9. Click Apply.
10. Reboot.
You do not need to reboot immediately, if you have additional changes to
make, but port forwarding does not take effect until the device is rebooted.
Range of ports
To define a port forwarding rule for a range of ports:
1. In ACEmanager, go to Security > Port Forwarding.