User guide

WAN/Cellular Configuration
Rev 1 Oct.13 121
Figure 5-10: ACEmanager: WAN/Cellular > Reliable Static Route (RSR)
Note: Configure all the other fields before setting the Enable/Disable RSR field. Once you
enable RSR, some fields on this page are not editable.
2. Select the interfaces for the primary and backup routes. The options are:
· Ethernet 1 (default for primary route). If you are using a GX Series device
with a Dual Ethernet X-Card installed, the additional Ethernet ports will
appear in the drop-down menu as Ethernet 2 and Ethernet 3.
· USB
· Wi-Fi (Available only if you have a GX Series device with a Wi-Fi X-Card
installed)
· Cellular (default for backup route)
3. Set the Destination IP/Network and Destination Subnet Mask.
To configure the RSR destination as a network, as shown in Figure 5-8, you
would enter:
· 64.100.20.128 in the Destination IP/Network field.
· 255.255.255.252 in the Destination Subnet Mask field.
To configure the RSR destination as an individual host, as shown in
Figure 5-9, you would enter:
· 64.100.20.128 in the Destination IP/Network field.
· 255.255.255.255 in the Destination Subnet Mask field.
4. Set the Tracking Object (Tracking Object 1 or No Tracking Object). Normally,
you would select Tracking Object 1 from the drop-down menu.
5. Under Tracking Object, leave the Enable/Disable Tracking Object set at
Disable until you finish configuring the other Tracking Object fields.
6. Enter the Test IP address (normally an IP address within the Traffic Selection
Criteria Network/Subnet).