User guide

ALEOS 4.3.4 Software Configuration User Guide
112 4114514
LTE Data
Service
For LTE, fallback to EV-DO networks. Options are:
• LTE Preferred (default)—EV-DO is used when LTE service is not available
• CDMA Only
• LTE Only
Note: For most users, it’s best to leave the default setting (LTE Preferred). When this option is
selected, your AirLink device connects to an LTE network if it is available and falls back to an EV-
DO network if LTE service is not available. If you choose another option and the selected network
is not available, the device will not be able to connect to the cellular network. For example, if you
select LTE Only and you are in an area where there is no LTE network available, the device will
not be able to connect to a cellular network until you change this setting.
Keep Alive (See Keepalive on page 116.)
Advanced
CDMA Mobile IP Options are:
• MIP Preferred (default)
• Disabled, SIP Only
• MIP Only
Network
Roaming
Preference
Automatic option allows home or home preferred network preference. Options are:
• Automatic (default)
• Home Only
Response to
Incoming Ping
When a ping is received by the device from a remote location, the Response to Incoming Ping
redirects it to the selected location.
• No response: the incoming ping is completely ignored
• ALEOS Responds (default): ALEOS returns to the Ping response.
• Pass to Host: The ping is forwarded to the DMZ host with any response from the host
forwarded back to the OTA location. If no host is connected, there is no ping response.
Note: Some Mobile Network Operators may block all ICMP traffic on their network. A ping sent to
the device from a remote location is not received.
LTE
Authentication
Mode
Specifies the authentication method to be used in the network PPP session. Options are:
• NONE (default)
• PAP
• CHAP
Network User
ID
Network User ID
The login that is used to login to the cellular network, when required.
• uid=user id (up to 64 bytes)
Command Description