User guide

WAN/Cellular Configuration
Rev 1 Oct.13 109
Network User ID Network User ID
The login that is used to login to the cellular network, when required.
• uid=user id (up to 64 bytes)
Network Password Network Password is the password that, when required, is used to login to the
cellular network.
pw=password (30 characters maximum).
Network Watchdog (minutes) Network connection watchdog
If there is no network connection for the number of minutes configured in this field,
the device reboots. This feature cannot be disabled.
• 5–255 minutes (allowed values)
• 120 minutes (default)
Set Carrier (Operator)
Selection
Manually specify an operator.
Enter the desired parameters in the following format:
mode[,format[,oper]]
• mode= 0: Automatic — any affiliated carrier [default]
• mode= 1: Manual — use only the operator <oper> specified
• mode= 4: Manual/Automatic — if manual selection fails, goes to automatic
mode
• format= 0: Alphanumeric (“name”)
• format= 2: Numeric
• oper=”name”
See also to +COPS and *NETOP?
Note: Not all carriers or accounts allow specifying the operator. If the carrier
doesn't support it, this command may appear to be ineffectual.
Current Radio Module Band Band reported by the radio module.
Setting for Band This feature enables advanced users to select the RF band range or technology
the AirLink device uses. Most of the time it’s best to leave this field at the default
setting (All bands) but there may be times when you want to select a band range or
technology that you know is more stable in the region where the AirLink device is
located. The list of options displayed depends on the radio module in your device
and its configuration. Possible options include:
• All bands (default)
• GSM 900/1800
• GSM ALL
• WCDMA ALL
• WCDMA 900/2100
Note: For some Mobile Network Operator SIM Cards, you may need to set the
radio band before installing the SIM card.
Field Description