User guide

WAN/Cellular Configuration
Rev 1 Oct.13 105
Advanced
Response to
Incoming
Ping
When a ping is received by the device from a remote location, the Response to Incoming Ping
redirects it to the selected location.
• No response: the incoming ping is completely ignored
• ALEOS Responds (default): ALEOS returns to the Ping response.
• Pass to Host: The ping is forwarded to the DMZ host with any response from the host
forwarded back to the OTA location. If no host is connected, there is no ping response.
Note: Some Mobile Network Operators may block all ICMP traffic on their network. A ping sent to
the device from a remote location is not received.
Network
Authentica-
tion Mode
Specifies the authentication method to use in the network PPP session. Options are:
• None
• CHAP
• PAP (default)
Network User
ID
Network User ID
The login that is used to login to the cellular network, when required.
• uid=user id (up to 64 bytes)
Network
Password
Network Password is the password that, when required, is used to login to the cellular network.
pw=password (30 characters maximum).
Check profile
1 Params
Enables checking and updating the Profile 1 Parameters. Options are:
• Enable
• Disable (default)
Not all Mobile Network Operators or account types support this feature.
NAI Sets the Network Access ID
Not all Mobile Network Operators or account types support this feature.
PHA Sets the IP address of the primary home agent
Not all Mobile Network Operators or account types support this feature.
SHA Sets the IP address of the secondary home agent
Not all Mobile Network Operators or account types support this feature.
MHSS Sets the home agent shared secret key
Not all Mobile Network Operators or account types support this feature.
MASS Sets the AAA shared secret key
Not all Mobile Network Operators or account types support this feature.
Network
Watchdog
(minutes)
Network connection watchdog
If there is no WWAN/Cellular network connection for the number of minutes configured in this field,
the device reboots. This feature cannot be disabled.
• 5–255 minutes (allowed values)
• 120 minutes (default)
Load PRL File The Load PRL File button allows you to download a Preferred Roaming List.
Update PRL The Update PRL button allows you to update your Preferred Roaming List.
Command Description