Owner`s manual

ASSEMBLY

SUBFRAME INSTALLATION:

Slide the subframe under the tractor between the

front and back wheels on the left side.

Lift the back part of the subframe and hook the

supports (item 1) by the back slot (as shown) on the

mounting pins (item 2).

Lift the front part of the subframe between the tractor

supports (item 3).

Secure in place n the square holes or round holes

(item 7) depending on the model of tractor with two

0.50 x 1.25" pins (item 4) and two 3 mm hair pins

(item 5).

IMPORTANT:

Make sure the bolt (item 8) is 7 1/2’’ to 8 1/4’’ from

the ground.

NOTE: If the holes are not aligned, loosen the

supports, install the pins and retighten the support

bolts tightly.

If the tractor supports (item 3) are too narrow, loosen

the heat shield bolts.

Adjust the mower’s cutting height knob to "0". Push

the tractor's lift arm completely towards the front in

order to lower the mower's suspension arms.

Secure the lift lever (item 1) as shown to the mower

lift arm with a 0.38 x 1.00 pin (item 2) and a 2 mm hair

pin (item 3).

Do the same operation on the other side.

WARNING

TO PREVENT INJURIES:

Stop the motor.

Apply parking brake.

Remove the ignition key.

Disconnect the wire from the spark plug(s) and

keep away from spark plug(s) to prevent accidental

starting.

Install the subframe

Install the lift lever