Owner`s manual

20
ASSEMBLY
Install the utility blade to the subframe as shown.
Make sure the blade is pushed in until locked into
place by the springs (item 1).
Note: If the utility blade does not scrape enough,
remove the helper spring.
Insert the handle (item 1) into the support (item 2) as
shown.
Install the handle (item 1) on the control rod (item 3)
as shown and secure with a 2.5 mm hair pin.
UTILITY BLADE INSTALLATION:
Refer to Utility Blade owner’s manual, parts
breakdown section for parts identification.
WARNING
FOR YOUR SECURITY:
Read the Utility Blade owner's manual for safety
precautions and rules.
Follow the assembly and operation instructions.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brakes.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
CAUTION
TO PREVENT INJURIES:
Always raise the attachment to reduce the
tension on the spring before applying or
releasing tension on the helper spring. Firmly
hold the handle when you release the tension
because the arm will kick back due to the tension
on the spring.
VERIFY TIRE PRESSURE:
Attachments should raise 3" to 4" above the ground
(no more, no less) if not, check and adjust tractor tire
pressure as follows:
Front tires: 20-25 psi
Back tires: 8-10 psi
Tire pressure must be even on both sides of the
tractor.
Install utility blade
Install handle