Owner`s manual

ASSEMBLY

CAUTION

TO PREVENT INJURIES:

Always raise the attachment to reduce the

tension on the spring before applying or

releasing tension on the helper spring. Firmly

hold the handle when you release the tension

because the arm will kick back due to the tension

on the spring.

Install the belt as shown.

NOTE: Do not hook the helper spring (item 4) to the lift

lever (item 9) right now. The belt must be adjusted

before installing the spring.

Apply tension on the belt by moving the tension arm

(item 5) towards the front.

Check the tension on the belt and adjust if necessary.

See maintenance section for adjustment instructions.

NOTE: Make sure the belt between the motor pulley

(item 1) and the pulleys (item 2) is parallel with the

ground.

Raise the rotary broom in order to install the helper

spring.

Move the tension arm (item 5) towards the back.

Hook the helper spring (item 4) in the eyelet (item 6) that

is welded to the lift lever (item 9).

Apply tension by moving the tension arm towards the

front and secure in the hole (item 8) with a 3 mm hair pin

(item 7).

CAUTION

Never use the Rotary Broom without the belt

guard.

Install the belt

Install the spring