Owner`s manual

ASSEMBLY

Remove the belt guard from the back of snowblower.

Move the tension arm (item 5) towards the back to

facilitate installation.

Install the belt on the snowblower by inserting it between

the two flat pulleys (item 1) and around the snowblower

pulley (item 2).

NOTE: Do not hook the helper spring (item 4) to the lift

lever (item 9) right now. The belt must be adjusted

before installing the spring.

Apply tension on the belt by moving the tension arm

(item 5) towards the front

Check the tension on the belt and adjust if necessary.

See maintenance section for adjustment instructions.

NOTE:

Install the belt under the tractor as shown and make

sure the bottom strand (item 3) between the snowblower

pulley and the left hand side pulley is not twisted. Make

sure the belt between the motor pulley (item 10) and the

pulleys (item 11) is parallel with the ground.

Raise the snowblower in order to install the helper

spring.

Move the tension arm (item 5) towards the back.

Hook the helper spring (item 4) in the eyelet (item 6) that

is welded to the lift lever (item 9).

Apply tension on the belt by moving the tension arm

towards the front.

Secure in the hole (item 8) with a 3 mm hair pin (item 7).

CAUTION

TO PREVENT INJURIES:

Always raise the attachment to reduce the

tension on the spring before applying or

releasing tension on the helper spring. Firmly

hold the handle when you release the tension

because the arm will kick back due to the tension

on the spring.

Install belt

Install helper spring

CAUTION

Never use the snowblower without the belt guard.