Owner`s manual

ASSEMBLY

Unhook the helper spring (item 6).

Install the handle support (item 1) on the left hand side

with a 3/8 x 1 1/4" hex bolt (item 2) and flange nut

already in place, a 3/8 x 1" hex bolt (item 3) and flange

nut.

Tighten firmly.

Insert the plastic grommet (item 4) in the handle support.

Install the handgrip (item 5) as shown.

Remove the hair pin (item 1) and unhook the adjusting

rod (2) from the pivot support.

NOTE: In order to facilitate the subframe installation,

rotate the pivot support towards the front.

Make sure that the other end of the push tube (item 3) is

secured in the second hole (item 5) with a pin (item 4)

and in the top hole (item 6) of the lift lever (item 7).

Adjust temporarily the overall length of the push tube to

33.68" by screwing or unscrewing the adjusting rod

(item 2).

FINAL ADJUSTMENT:

After installing the attachment (Snowblower, Broom

or Blade) make sure the lift mechanism is lowered

to its limit. Readjust the adjusting rod (item 2) by

screwing or unscrewing until the rod is even with

the hole on the pivot support.

Install handle support

Adjust push tube