User's Manual

Pair up with the subwoofer

After the soundbar and the subwoofer are powered on at the same time, make sure that the soundbar switches

to BT mode. (Do not connect the soundbar Bluetooth to the device firstly, wait for the soundbar to pair with the

subwoofer before connecting to device. Usually the pairing method will be fastest in BT mode.) When they are

powered on, the subwoofer blue indicator flashes slowly, short-press the subwoofer WPS button switch, the blue

indicator flashes quickly and enters the pairing state automatically. When the soundbar is paired with the subwoofer,

the subwoofer blue indicator light is always on.

When the soundbar is connected to the subwoofer, the soundbar is entered into standby or powered off,

and the subwoofer can not be searched for the soundbar within 5 minutes, it will be automatically on standby,

and then the indicator will be red. When the soundbar is turned on, the subwoofer will be awakened and connected to

the soundbar, the blue indicator light is always on.

••The maximum Bluetooth connection distance in an open space between the soundbar and subwoofer

should not exceed 8m.

••To avoid sound quality interference caused by wireless signal interference, when you are playing 1000002681

soundbar, please ensure it is kept at an appropriate distance from other WIFI devices to avoid wireless signal

interference.

••The flashing blue LED on the subwoofer will turn red if the paired soundbar is turned off, on STANDBY or not

connected to the power. It is indicated that the subwoofer has also entered into STANDBY mode.

••If not paired successfully, disconnect the subwoofer and soundbar from each other:

1. Turn off the soundbar and subwoofer by unplugging the AC plug from the socket.

2. Wait 3 minutes before replugging the AC plug into the power socket again. Ensure the soundbar and subwoofer

are connected to the main power at the same time.

3. Press and hold the subwoofer’s rear panel WPS button to reset the connection, so that the soundbar and

subwoofer can be reconnected again.

Note:

Note: The software (system folder) of the soundbar and subwoofer cannot be decompressed to the same USB disk at

the same time, so as not to confuse the upgrade software.

Software upgrading

Soundbar Upgrade

Upgrade the soundbar software: Unzip the the entire system software folder of the soundbar in the root directory of

the USB disk. After plug the power cord of soundbar into main socket and power on, then insert the USB disk into the

USB port of soundbar, “UP” will be shown on the display after a while, then “UPSC” will be shown in around 10 seconds,

after a while display will be automatically on standby and show “--”. It is indicated that upgrade is complete.

Subwoofer upgrade

Upgrade subwoofer software: Unzip the the entire system software folder of the subwoofer in the root directory of the

USB disk. After plug the power cord of subwoofer into main socket and power on, the blue indicator light flashes slowly,

then insert the USB disk into the USB port of subwoofer. around 3-5 seconds the blue indicator light on subwoofer will

go out. After the light is off, wait for blue indicator light to flash slowly again, upgrade is complete and then pull out the

USB disk.

After both soundbar and subwoofer are completely upgraded, re-plug the power cord into main sockets

in around 2 minutes, before using, please make sure the soundbar and subwoofer re-paired each other firstly.

Usually the pairing method will be fastest in BT mode.