User Manual

INTVL
TIMER CONTROLS
SHUTTER CONTROLS
CH
BATT
hours minutes seconds
8
The Wireless ShutterBoss allows you to
control the amount of time between a series
of shots. Choose an interval that is longer
than your exposure time. If using a flash, be
sure to set an interval that is longer than your
flash recycle time.
. Turn on the receiver by pressing the
Power button until the display comes on.
2. Set your camera exposure.
3. Use the arrow button on the transmitter
to select INTVL under the Timer
Controls. Press the left and right
arrows until INTVL is displayed.
4. Press the set button in the middle of
the arrow button to change the exposure
Interval setting. Use the left and right
arrows to move between hours, minutes,
and seconds. Use the up and down arrows
to change the time values.
5. Press set button again to accept your
selection.
6. Continue on to other Timer Control
settings or press Timer Start/Stop to
begin the exposure process.
TIMER CONTROLS: INTERVALS