User Manual

BULB
TIMER CONTROLS
SHUTTER CONTROLS
CH
BATT
3
Bulb exposures under the Shutter Control
settings give you manual control over a long
exposure. To preset long exposure times, use
the Timer Control settings described later in
this manual.
. Turn on the receiver by pressing and
holding the Power button until the display
comes on.
2. Set your camera to bulb exposure.
3. Use the arrow button on the transmitter
to select bulb mode. Press the
left and right arrows until BULB is
displayed at the bottom of the LCD.
4. Press the transmitter’s shutter release
button halfway to wake or focus your
camera (if set to Auto Focus). The LEDs
on the transmitter and receiver will turn
green.
5. Fully depress the shutter release button
on the transmitter. The LEDs will turn red
and the shutter will be triggered. The LEDs
will continue to blink red and the screen
will display the seconds of exposure.
6. Press the shutter release button again
to end the bulb exposure.
SHUTTER CONTROL: BULB SHOT
In bulb mode, the screen will display the
seconds of your exposure.