User Manual

Default Screen
21
This restores the FreeWave
IR Commander to the factory
default settings. This will erase
all current settings and replace
them with the default settings.
To restore the factory settings,
press and hold the Set button for
five seconds until the Commander
reverts to the default screen.
The S1 optical slave mode is ideal for
shooting with a remote flash, such
as a monolight, that has an optical
sensor. In this mode, power output is
adjusted on the slave flash, rather than
the Commander. Unlike the TTL and
Manual modes, S1 optical slave mode
does not employ groups and channels.
To set S1 mode:
1. Press and hold the Mode button for
five seconds until the S1 indicator
appears onscreen.
FACTORY RESETS1 OPTICAL SLAVE MODE
2. Turn on your slave flash, and set it to
optical slave mode. Make sure your
slave flash’s IR sensor is facing the
Commander.
3. Set the power output on your slave
flash.
For information on how to perform
these procedures with your particular
flash, refer to your flash’s user manual.
To exit S1 mode, press
the Mode button.