User Manual

12
TURNING ON THE FREEWAVE IR COMMANDER
To on turn the FreeWave IR
Commander, slide the power
switch to the On position. When
turning o the Commander, it will
remember all your current settings.
Once mounted on your camera, you
can rotate the Commander for line-
of-sight positioning. The Commander’s
transmitter should be facing the flash’s
IR sensor, and there should be no
obstructions between the two units.
Test Button/Ready Light
The ready light indicates the status
of the Commander. When it glows
red, the Commander is ready to
be fired. When the light is o,
the Commander is recycling.
To fire a test flash, press
the Test [ ] button.
Tip: After changing any settings in your
wireless setup, press the test button to fire
a test flash and confirm your new settings.
The slave flashes will fire at a nominal
power setting for firing confirmation.