User Manual

4
After you’ve set both the Transmitter and
Receiver to the same channel, place the
correct batteries in the devices. Insert two
AAA batteries (not included) into the battery
compartment of the Receiver, being careful
to orient them with the correct polarity
marked on the inside of the battery cover.
Then, open the battery compartment on the
Transmitter and insert two AAA batteries,
again installing with correct polarity.
On the side of the Receiver is a switch
labeled Flash/O/Camera. To conserve
battery power, you should keep the
switch in the O position except when
the Receiver is actually in use. Slide the
switch to “Flash” if you’re using it as a
remote flash trigger or to “Camera” if
you’re using the set as a remote wireless
camera shutter trigger. The Transmitter
battery has a life of approximately two years
in standby mode. Slide the Transmitter’s
Funuction/O switch to the O position
when the Transmitter is not in use.
Note: Many modern flashes and cameras have
a Sleep mode. You must turn o the Sleep mode
in your flash or camera before using the Fusion
Basic. Refer to your flash or camera user manual
for instructions.
POWERING UP